Usage areas
- Indoor and outdoor, all in dimensions ceramic, Pranita, cotton, clinker, pine mosaic, marble, a natural stone veneer of materials 2-20 mm between the joint of the gaps in the filling used.
- Swimming pool, this warehouse pipi wet bulky in spaces horizontal and vertical in applications used.
- exterior, terrace, underfloor heating system, warehouse intense like pedestrian and load of traffic and sudden temperature changes are in places used.
- Bath, shower, toilet like wet in volumes, kitchen like easy pollutable in spaces, horizontal And vertical in applications, Perfect conclusion gives.
Features and Advantages
- Difficult gets dirty, easy cleared.
- Juice pushes.
- Drinking juice in warehouses to use suitable.
- High flexibility has.
- Freezing - dissolution cycle resistant.
- Fast by curing your space quick use to be opened provides.
- To wear it is durable. Splinter proof.
- Smooth surface provides.
Application Preparation
- The joint of the gaps dry, clean, And durable to be attention should be done.
- Application to do joint gaps between sticking to hindering dust, dirt, and cement residues from the surface should be purified.
- Joint spaces tile of the thickness -most little 2/for much empty should be.
- Invoices while laying joint into the spaces overflowing glue or mortar yet when fresh should be cleaned.
- Very absorbent high tiles, high temperature or Windy weather conditions pipi cases joint spaces clean This with should be moistened.
Instructions For Use
- Joint Filling app before glue must be cured. ·
- Super Fugaflex should be poured slowly over the amount of water recommended in the technical table and a homogeneous mixture is obtained. until it should be mixed. work low cyclic mixer with should do. Application in your instruction unspecified any no contribution should be made. Of water than specified more or put less to crack, to dust and color to your flaws from where it could be.
- The prepared mortar should be rested for 5-10 minutes to mature. 1-2 minutes before starting the application again should be mixed.
- Work after being prepared later 50 min in should be used.
- The mortar should be spread on the surface and the joint gaps should be filled with diagonal movements with a rubber trowel and the excess should be scraped off. from the surface should be taken.
- When the material filled into the joint cavity loses its water and becomes dull, usually after about 10-20 minutes, The surface should be cleaned in circular motions with the help of a damp sponge. Waited in the sun or high absorbency covering of materials between, direct sun, wind like suitable non-environment in the conditions made in applications this period may be shortened. From the time of the deletion before or when you do it with a very watery sponge color fluctuation the problem can be encountered. Sponge chic at intervals should be cleaned.
- After making sure that Super Fugaflex is dry enough to not discharge from the joint, the residues remaining on the surface are removed. dry One cloth should be cleaned.