Description
White cement based, resin and polymer added, waterproof, high adhesion and strength exterior coating. High resistance to water and frost. It has a natural decorative appearance.
Field of Application
It is used as a decorative coating on exterior surfaces, thermal insulation systems, all kinds of mineral surfaces, on the exterior, thermal concrete, in residential, shopping malls, and hospitals, and horizontal, vertical, and overhead applications.
Packaging
25 kg/Beutel (±02%)
Properties
- It is easy to apply and shape.
- It shows high resistance to all kinds of climatic conditions.
- It is resistant to external weather conditions and water repellent.
- It prevents moisture accumulation.
- Resolves surface defects.
- It is long-lasting and does not burn and swell.
- It creates a homogeneous decorative image after application.
- It has vapor permeability.
- It can be painted with exterior paint.
Surface Preparation
Surface Quality: The surfaces must be clean, smooth, solid, and free from all kinds of dust, oil, dirt, rust, mold oil, detergent-like substances, and waste. Surfaces should be smooth, weak parts should be removed. If there are cracks or cavities on the floor or wall to be applied, they should be repaired with suitable repair mortars.
Application
PASSIVE HOUSE Decorative Plaster is added slowly in clean and cold water and mixed with a low-speed mixer for about 10 minutes until the mixture becomes lumpy. The mixed mortar is rested for 5 minutes and mixed again. If necessary, the consistency of the mixture is adjusted again by adding water. The required amount of water should be adjusted
according to the weather conditions. While mixing with the machine, it should be paid attention that the particles in the product are not abraded. An equal amount of water should be used for each batch of mortar mix. Otherwise, pattern and tone differences may occur on the surface. The prepared mixture should be consumed within 2 hours depending on the weather conditions. The prepared homogeneous mixture is applied smoothly to the surface with a steel trowel and excess material is cleaned from the surface to obtain a layer thickness in the product. The pattern should be applied within a maximum of 10 minutes after PASSIVE HOUSE Decorative Plaster is applied homogeneously on the application surface. To obtain fine-grain texture, the pattern is given with circular movements with a plastic or polyurethane trowel. The trowel surface should be peeled off frequently while designing. Products with the same charge number should be used on the same surface. To avoid overlapping on large areas, care should be taken to ensure that sufficient numbers of people are employed during the application and that the material is applied without interruption until it reaches the joint ends or detail corners.