Surface quality
Surfaces are clean, smooth, and solid, and all kinds of dust, oil, dirt, rust, mold oil, and detergent. like sticking to inhibitory substances and waste should be purified. Surfaces in the balance should be weak parts should be removed. APPLICATION to do ground or on the wall crack, cavity there is whereas suitable fix fees with fix should be done. To the PS TILE ADHESIVE app 3-4 days later must be passed.

Surface preparation
Marble, ceramic, and pallet Ian over APPLICATION if it will be done surfaces should be roughened. Concrete ground damp must be, but This b I bump should not be. G a z concrete, gross concrete, plaster plate like on surfaces liner use recommendation is done.

Mixing
Put it in a clean container free of any non-adhesive material. 7, 0 - 7, 5 liters of clean, clear water taken from the ambient temperature is poured. 25 kg in powder form into a container filled with water PS TILE ADHESIVE in the bag is emptied. A homogeneous mixture without lumps is obtained with a low-speed mixer. The product is mixed until mixed. obtained at the end of the processed mortar for 3 min rest and again 12 min homogeneous until it becomes much should be mixed.

• Application Notes / Limitations
  Ceramic behind dusty surface (engop) if any hard brush with by washing should be cleaned.
• The prepared mortar is spread on the surface with a notched trowel with the appropriate tooth size. On the combed mortar covering materials (ceramic, tile, etc.) 15 min inside should be attached. This duration passed whereas mortar from the surface and coatings scraped off should be discarded. Again ready mortar by making should be applied.
• Product to the skin in contact irritation can do. Work dress, protector glove, mask, and glasses should be used. Whereas before starting hand protector
  the cream is also drivable.
• Eye contact with mortar in case of eyes immediately warm This must be washed and a doctorate should be applied. 5 ° C of under will stay environment in the conditions definitely to protect should be taken nylon with around should be closed or heat insulation plates by laying down your product donate exposed to stay must be prevented.
• (+) 35 ° C on you at temperatures definitely to protect should be taken nylon with around should be closed or heat insulation plates by laying down your product moment This to the loss exposed to stay must be prevented.
• PS TILE ADHASE from the implementation -most little 24 hours later, joint to the fill must be passed.
• Foreign article additional Please do not.
• From the app then pole sunlight, severe wind, high weather temperature (above +35 ° C) rain, and should be protected against adverse weather conditions such as frost. Before PS TILE ADHESIVE is fully cured and hardened, hands And detergent with should be cleaned.
• From the app immediately later, yet without hardening, equipment This with
  should be cleaned. Product after hardening later mechanical methods should be cleaned.

Dowmload Product Info

Cement-based high-performance ceramics and tiles adhesive